Instructions:

1. Pop off plastic Panel on the back of the auxiliary mirror using a regular flat screw driver.

2. Loosen screws A & B inside the Auxiliary Mirror unit from the top angle of the mirror - about 1/2 Inch using either a 1/4" socket or phillips head screw driver. NOTE: If you loosen screws A & or B too much, you could lose the bracket inside the mirror housing. If this happens, follow instructions A-D on instruction set B.

3. Slide the new mirror over the existing side view mirror allowing the bracket to slide between the mirror and the mirror's housing.

4. Tighten screws A & B until the mirror is securely connected.

5. Snap plastic panel back on the mirror (note: this panel or the whole mirror can be painted to match your vehicle).

6. Adjust the new mirror to desired angle using thumbs.